Description
KNS Gen 2 Mod 2 AR-15/M16 ANTI-ROTATION HAMMER TRIGGER PINS SET Red .154 Standard
These are the Generation 2 Mod 2 pin sets. These are the STRONGEST pins that can be produced and were designed to withstand the high impact of full and semi-auto 9mm, .223, and 7.62mm suppressed weapons. The pins are stainless steel.
Black sideplates are black nitride treated, all other color options are DuraCoated.
An absolute must-have for all NFA owners.
They will also protect your AR-15. Special anti-creep retainers prevent wear on your irreplaceable registered NFA receiver. Pin installation tool & 2 Torx wrenches included. No modification to firearm required. THE TORQUE SPEC ON THE SCREW IS 11 inch/lbs. MAXIMUM. We recommend 8INCH/LBS of torque.
IMPORTANT NOTE: The external width of some AR receivers may vary in the trigger/hammer pin area depending on the manufacturer. The pins being slightly too long will not affect the function or performance.
Standard size .154″
.155″ Oversized Pins help improve accuracy andtrigger control by tightening up any trigger slack that may exist inworn or new receivers. Standard-sized pins drop-in and require nomodification to the receiver; they are recommended for all new receivers. Oversized pins may require the use of a 3.95mmReamer.
Comments:
“If you are adding A drop in trigger this is a must. Over 2000 roundswith no problems.”
“Works exceptionally to prevent any pin slippage and gives the carbine a custom look to boot.”
SPECS: 416 stainless steel pins. .900”(22.8mm) long, .154″ (3.91mm) or .155″ (3.93mm) diameter. Set includes (1) hammer pin, (1) trigger pin, (2)screws, (2) anti-rotation links, hex wrenches, and installation tool. Anti-RotationLinks – Steel, Parkerized finish. Retaining Screws – Steel,black oxide finish.
For Rock RiverNational Match triggers use the .1555 only.
Make sure gunis unloaded and pointed in a safe direction.
Instructions:
Trigger pin is internally threaded on each end.Use pointed tool tosimultaneously push out old trigger pin and feed in new trigger pin.Push out old hammer pin about 1/8th” with a punch and finish pushing outwith new hammer pin.Install connectors over ends of hammer pin andalign holes over trigger pin.Install screws in trigger pin.Do notover-tighten, snug will do.KEEP WELL OILED.
